Microstructure and mechanical properties of cast (Al–Si)/SiC p composites produced by liquid and semisolid double stirring process
2000; Maney Publishing; Volume: 16; Issue: 5 Linguagem: Inglês
10.1179/026708300101508072
ISSN1743-2847
Tópico(s)Aluminum Alloy Microstructure Properties
ResumoAbstractA stirring process containing two steps, i.e. liquid and then semisolid stirring, was used to produce SiC particle reinforced aluminium matrix composites. The major advantages of this process are that full wetting of SiC particles by molten aluminium can be readily achieved at relatively low stirring rates, and undesirable Al4 C3 is not formed at the Al/SiC interface due to lower processing temperatures. Cast Al–Si matrix composites reinforced with 15 and 20 vol.-%SiC particles were produced in the present work. The mechanical properties of the composites were evaluated under the conditions of investment mould casting and heat treatment. For the composites obtained without employing semisolid stirring, the aggregation of SiC particles observed in the microstructure of composites resulted in quite poor mechanical properties. Observations and analyses indicated that some Al/SiC interfaces were very clean, and a reaction product of spinel MgAl2O4 was also found at some Al/SiC interfaces. Silicon dioxide (SiO2 ) was found to exist on the surface of as purchased and 250°C dried SiC powders. This SiO2 is involved in the spinel reaction at the interface between the SiC particles and the matrix in the present Al/SiC composites.
Referência(s)