Coseismic Coulomb stress changes caused by the Mw6.9 Yutian earthquake in 2014 and its correlation to the 2008 Mw7.2 Yutian earthquake
2015; Elsevier BV; Volume: 105; Linguagem: Inglês
10.1016/j.jseaes.2015.02.025
ISSN1878-5786
AutoresYujiang Li, Lianwang Chen, Shaofeng Liu, Shuxin Yang, Xingyue Yang, Guangwei Zhang,
Tópico(s)Earthquake Detection and Analysis
ResumoA three-dimensional viscoelastic finite element model of the Qinghai–Tibet Plateau and its adjacent regions was used to explore the relationship between the Mw7.2 Yutian earthquake in 2008 and the 2014 Mw6.9 Yutian earthquake. We further analyzed the Coulomb failure stress change caused by the Yutian Mw6.9 earthquake on faults surrounding the Bayan Har block and discussed the relationship between the Coulomb stress change and aftershock distribution. The preliminary results showed that: (1) The Coulomb failure stress change caused by the Mw7.2 Yutian earthquake in 2008, which was projected on the slip direction of the 2014 Yutian Mw6.9 earthquake, exceeded the earthquake triggering threshold of 0.01 MPa, implying an apparent triggering effect. Specifically, the coseismic Coulomb failure stress changes were 0.0167 MPa and 0.0170 MPa when assuming apparent friction coefficients of 0.4 and 0.6, respectively. The Coulomb failure stress changes, including viscoelastic relaxation effects, were 0.0187 MPa and 0.0194 MPa respectively. Combined with the tectonic stressing rate, the Mw6.9 Yutian earthquake in 2014 was advanced 21.4–24.9 years by the 2008 Mw7.2 Yutian earthquake; (2) The stress changes derived from the viscoelastic relaxation effect were much less than that from the coseismic effect, which was possibly interpreted as the shorter elapsed time between the two earthquakes relative to the characteristic time; (3) The Coulomb failure stresses increased on the mid-northern segment of the Altyn Tagh fault, the middle segment of the Mani-Yushu fault and the western segment of the eastern Kunlun fault, which demonstrated increasing seismic potential. In particular, the Coulomb failure stress on the middle segment of the Altyn Tagh fault increased by 2.8 × 103 Pa, the most significant increase. In contrast, the Coulomb failure stress decreased on the western segment of the Mani-Yushu and Minjiang faults, with the western segment of the Mani-Yushu fault dropping by 3.6 × 103 Pa. The Coulomb stress changes on most faults surrounding the Bayan Har block were calculated to have increased, while the Minjiang fault on the eastern boundary was inhabited due to the enhancement of coseismic compressive stresses; (4) Combining the relocation of the aftershock sequence with the coseismic failure stress change, we concluded that the Mw6.9 Yutian main-shock triggered the aftershock sequences.
Referência(s)