Laboratory device to characterize electrokinetic geocomposites for fluid fine tailings dewatering
2015; NRC Research Press; Volume: 52; Issue: 4 Linguagem: Inglês
10.1139/cgj-2014-0031
ISSN1208-6010
AutoresSébastien Bourgès-Gastaud, Guillaume Stoltz, Patricia I. Dolez, Éric Blond, N. Touze-Foltz,
Tópico(s)Landfill Environmental Impact Studies
ResumoThe oil sands industry usually leads to the production of large quantities of mineral waste, such as fluid fine tailings (FFT), whose disposal is often challenging. Electrokinetic geocomposites (eGCPs) installed into the FFT disposal area may improve in situ dewatering, as eGCPs can drain water expulsed during FFT consolidation as well as impose a voltage across FFT to displace water by electro-osmosis. This paper presents a laboratory device specifically developed to evaluate eGCP performance for sludge dewatering. Based on the oedometer principle, the device aims at studying sludge consolidation as a function of boundary conditions (mechanical stress and (or) voltage), with drainage and electrical conduction ensured by two eGCPs positioned on both sides of the sludge layer. Preliminary results obtained with one particular eGCP are presented: the solids content was increased from 42% to 66%, which led to a significant improvement of the shear strength from nearly 0 kPa to a mean value of 40 kPa. The energy required for this experiment was 71 W·h (3.5 kW·h/(m 3 of sludge)). The filtration performance remained satisfactory; the sludge particles were retained upstream of the filter, with clean water flowing through.
Referência(s)