Artigo Revisado por pares

Catalytic oxidation of benzene with ozone over alumina-supported manganese oxides

2004; Elsevier BV; Volume: 227; Issue: 2 Linguagem: Inglês

10.1016/j.jcat.2004.07.029

ISSN

1090-2694

Autores

Hisahiro Einaga, Shigeru Futamura,

Tópico(s)

Oxidative Organic Chemistry Reactions

Resumo

Catalytic oxidation of benzene with ozone over alumina-supported manganese oxides was carried out at room temperature (295 K) to investigate the behavior of benzene oxidation and COx formation. The ratio of the decomposition rate for ozone to that for benzene was found to be 6, independent of ozone concentration, reaction times, and the amount of Mn loading. A linear correlation was observed for the amount of ozone decomposed and that of COx formed, whereas deviation from linearity was observed between the amount of ozone decomposed and that of benzene reacted. Carbon balance was in the range of 26–37% due to the formation of two types of intermediates, weakly bound compounds including formic acid and strongly bound surface formate and carboxylates. Catalyst was significantly deactivated due to the buildup of the intermediates on the catalyst surface during the course of benzene oxidation. The weakly bound compounds were removed by heat treatment at 573 K in the O2 flow. The strongly bound surface formate and carboxylates were oxidized to COx by further heating up to 723 K. The deactivated catalyst was regenerated by the heat treatment.

Referência(s)
Altmetric
PlumX