Portal de Periódicos da CAPES

Injection molding of bushes made of tribological PEEK composites

2007; Budapest University of Technology and Economics; Volume: 1; Issue: 12 Linguagem: Inglês

10.3144/expresspolymlett.2007.113

1788-618X

Fabrizio Quadrini, Erica Anna Squeo,

Polymer Nanocomposites and Properties

Polyetheretherketone (PEEK) composites have been extensively studied because of the excellent tribological behavior among plastics.However, laboratory specimens and tests are generally discussed, whereas application studies on industrial components are infrequent.In this paper, an injection molded bush made of tribological PEEK was analyzed to correlate wear behavior and molded material structure.Bushes were tested under unlubricated sliding conditions by means of a short wear test.Surface analysis, differential scanning calorimetry (DSC) and optical microscopy were used to evaluate the distribution of the different composite fillers (polytetrafluoroethylene, PTFE, graphite particles and carbon microfibers) and their effect on the final bush behavior.A significant lack of homogeneity was observed in the molded bush and black bands appeared on the shaft surface after testing due to the sliding.The bush geometry and the injection molding process should be optimized to allow the best tribological behavior of the molded material under working conditions.