On the sliding and profile of a liquid droplet on a rotating disk

2009; Wiley; Volume: 39; Issue: 1 Linguagem: Inglês

10.1002/htj.20276

ISSN

1523-1496

Autores

Kenji KATOH, Mituyoshi Higashine, Tatsuro WAKIMOTO, Ryohei Masuda,

Tópico(s)

Fluid Dynamics and Heat Transfer

Resumo

Abstract This theoretical and experimental study was conducted to investigate the critical condition at which a liquid droplet starts to move on a rotating disk. The critical rotational speed ω was theoretically calculated based on the force balance between the surface tension and the centrifugal force, where ω was experimentally measured for each combination between three kinds of test plates and test liquids. The movements of droplets were judged from the careful observation of infinitesimal motion of the three‐phase contact line. The calculated rotational speeds agreed well with measured ones for arbitrary contact angle when the droplets were set on the plate. The three‐dimensional surface profiles of droplets were calculated from the approximate Laplace equation in which the contact line was assumed as the combination of two ellipses with different ratio of measure to minor axis. The measured profiles on the rotating disk were approximated well by the method proposed in this study. © 2009 Wiley Periodicals, Inc. Heat Trans Asian Res; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20276

Referência(s)
Altmetric
PlumX