Sticky Wax Infiltration in the Preparation of Sawed Undecalcified Bone Sections
1970; Taylor & Francis; Volume: 45; Issue: 4 Linguagem: Inglês
10.3109/10520297009067475
ISSN0038-9153
Autores Tópico(s)Endodontics and Root Canal Treatments
ResumoThe undecalcified bone specimen was surfaced by an ordinary motor-driven circular saw. After thorough drying in air, the specimen was infiltrated with melted Caulk sticky wax (L. D. Caulk Co., Milford, Del., 19963) without casting in a block. The specimen was affixed to the Gillings-Hamco thin-sectioning machine with cut surface parallel to the circular diamond blade. Prior to sawing each section, the specimen surface was blown dry and coated with a thin supporting layer of stick wax. The section was then attached to an albumen-coated glass slide with the newly cut surface facing the slide. After drying in room temperature, the slide was soaked in xylene to partially dissolve the sticky wax, and the loosened residue was removed subsequently by gentle brushing. The section was mounted and covered with a coverglass. Sections 50-100 μ thick were prepared satisfactorily by this method. The advantages of using sticky wax as an infiltration medium depend on its physical properties: it is gluey when melted, and holds the bony trabeculae together; it becomes hard and nonsticky at room tempperature, and can be sawed together with bone tissue. Since a new layer of wax blends readily with the old wax surface, it allows the important supportive coating of wax to be added to the sawing surface for each section cutting
Referência(s)