Portal de Periódicos da CAPES

Comparison of the preparation of PLGA–BSA nano- and microparticles by PVA, poloxamer and PVP

2007; Elsevier BV; Volume: 319; Issue: 1-3 Linguagem: Inglês

10.1016/j.colsurfa.2007.07.011

1873-4359

Tivadar Feczkó, Judit Tóth, János Gyenis,

Nanoparticle-Based Drug Delivery

The objective of our study was to prepare nano- and microparticles economically considering some practical parameters such as size and encapsulation efficiency as well as ability of particle recovery. Bovine serum albumin (BSA) model protein was encapsulated by poly(d,l-lactide-co-glycolide) (PLGA) using a multiple water-in-oil-in-water emulsion-solvent evaporation technique. The effect of three surfactants: polyvinyl alcohol, poloxamer, and polyvinyl pyrrolidone, used in the outer water phase, on the properties of particles was investigated. The emulsifier/PLGA mass ratio played an important role in the preparation procedure of the particles. This ratio was found to be approximately 1 for polyvinyl alcohol (PVA) if the aim was to formulate nanoparticles with narrow size distribution ( 90%). Although, a ratio of 2:1 was sufficient to produce submicron particles by poloxamer with high yield, more than 70% and 90% encapsulation efficiency required minimum 4 and 10 emulsifier/PLGA mass ratio, respectively. Five times more PVA and 10 times more poloxamer than the PLGA mass were necessary to obtain nanoparticles which were easy to redisperse after centrifugation. Microparticles released more BSA than nanoparticles prepared by PVA, however, the situation was reverse with poloxamer. Microparticles formulated by polyvinyl pyrrolidone (PVP) showed the fastest in vitro release.