USE OF COMPUTATIONAL FLUID DYNAMICS TECHNIQUES TO ASSESS DESIGN ALTERNATIVES FOR THE PLENUM CHAMBER OF A SMALL SPRAY DRYER
2001; Taylor & Francis; Volume: 19; Issue: 2 Linguagem: Inglês
10.1081/drt-100102902
ISSN1532-2300
AutoresD.B. Southwell, T.A.G. Langrish, David F. Fletcher,
Tópico(s)Cyclone Separators and Fluid Dynamics
ResumoThe inlet region of a pilot-scale, co-current spray dryer was simulated using the proprietary Computational Fluid Dynamics (CFD) codes, CFX4 and CFX5. Several design alternatives were considered for correcting uneven inlet air distribution, which is known to influence spray dryer performance and airflow patterns. The simulations were used to assess each alternative prior to construction, assuming isothermal and incompressible flow conditions. Experimental measurements were compared with the simulation results for the original and one modified design. Drying air is supplied to this dryer via an overhead pipe feeding an annular plenum chamber, of diameter 400 mm, surrounding the atomiser. A distributor plate with two concentric rings of 50 holes, each of 5 mm diameter, forms the base of the plenum chamber. A three-dimensional grid was required to model each of the 100 holes separately and to consider the asymmetric flow behaviour. The resulting grid consisted of about 532,000 cells. The CFD simulations proved useful in predicting the trends in flow distributions in each of the designs.
Referência(s)