Portal de Periódicos da CAPES

Boric Acid Self-Lubrication of B 2 O 3 -Filled Polymer Composites

1999; Taylor & Francis; Volume: 42; Issue: 3 Linguagem: Inglês

10.1080/10402009908982258

1547-397X

Brian R. Burroughs, Jong-Hwan Kim, Thierry A. Blanchet,

Lubricants and Their Additives

Utility of boric oxide particles in PTFE and epoxy composite materials, in sliding contact with stainless steel, is explored. Boric oxide filler can provide PTFE with a two-decade reduction in wear rate, to 10−5 mm3/N-m. With adequate ambient humidity reduced wear rate can be achieved without inducing counterface abrasion, and the friction of PTFE is further reduced slightly. In such environments, boric oxide fillers can also reduce friction coefficient of epoxy from μ>0.7 to as low as μ=0.07. This lubrication mechanism results from replenishment of lubricous boric acid lamellar solid provided to the sliding interface by reaction of boric oxide with ambient water. Maintenance of the lubricating effect depends upon a sufficient rate of boric acid formation, relative to subsequent removal by wear. It is demonstrated that this formation/removal balance is affected by relative humidity and volume fraction of boric oxide filler, as well as normal load and sliding speed.