Portal de Periódicos da CAPES

Effect of Acetabular Cup Position and Orientation in Cemented Total Hip Arthroplasty

2001; Lippincott Williams & Wilkins; Volume: 388; Linguagem: Inglês

10.1097/00003086-200107000-00020

1528-1132

Kazuo Hirakawa, Naoto Mitsugi, Tomihisa Koshino, Tomoyuki Saito, Yasusuku Hirasawa, Toshikazu Kubo,

Orthopedic Infections and Treatments

Long-term clinical results of total hip arthroplasty for patients with developmental acetabular dysplasia of the hip have been reported, but placement of the femoral head center or cup orientation remains controversial, especially with a severe anterolateral shallow acetabulum or dislocated femoral head. Results of 41 Müller and 34 Harris Design 2 cemented total hip arthroplasties were evaluated for developmental dysplasia of the hip. The femoral head center and acetabular cup inclination angle were measured from the interteardrop line. Linear wear and wear direction were measured using the Livermore technique. The best position of the femoral head center was less than 35 mm vertically from the interteardrop line and 25 mm laterally from the teardrop. Femoral head center analysis showed that hips with the cup in a lateral and superior cup position all were revised, but a superior and medial position combined with a cup inclination angle less than 40 degrees did not require revision. Hips with a cup inclination angle more than 45 degrees had superior and lateral penetration patterns of the polyethylene. However, hips with an inclination angle less than 35 degrees and medial placement had medial head penetration patterns. With these all-polyethylene monolithic cemented cups, regardless of the femoral head diameter or cup thickness, better long-term results occurred with a cup inclination angle of 40 degrees or less and medial position of the cup.