Portal de Periódicos da CAPES

Aortic Aneurysm: Construction of a Life-size Model by Rapid Prototyping

2001; Elsevier BV; Volume: 15; Issue: 2 Linguagem: Inglês

10.1007/s100160010054

1615-5947

Patrick Lermusiaux, Cécile Leroux, Jean Claude Tasse, Lucien Castellani, Robert Martinez,

Cardiac, Anesthesia and Surgical Outcomes

Development of new endovascular techniques for repair of abdominal aortic aneurysm (AAA) requires the use of experimental models. Stereolithography is a rapid prototyping technique used in industry to prototype parts during the design phase. A stereolithography apparatus (STL) employs laser technology to build a digital model layer by layer with photopolymer resin. The purpose of this study was to use this technology to produce a life-size AAA model. Data were acquired by CT scan and stored in DICOM 3 format. Specifically designed software was used for 3-D imaging and conversion of data to a standard STL format. Two replicas were made: one to scale and the other 3 mm larger. The final model was made by pouring silicone rubber or polyurethane into the mold over the life-size model so as to obtain a sturdy, life-size, soft, transparent plastic casting. Arterial models made for living subjects with these rapid prototyping techniques can be used to simulate surgical procedures, calibrate imaging modalities, and design new stent grafts. Development of new endovascular techniques for repair of abdominal aortic aneurysm (AAA) requires the use of experimental models. Stereolithography is a rapid prototyping technique used in industry to prototype parts during the design phase. A stereolithography apparatus (STL) employs laser technology to build a digital model layer by layer with photopolymer resin. The purpose of this study was to use this technology to produce a life-size AAA model. Data were acquired by CT scan and stored in DICOM 3 format. Specifically designed software was used for 3-D imaging and conversion of data to a standard STL format. Two replicas were made: one to scale and the other 3 mm larger. The final model was made by pouring silicone rubber or polyurethane into the mold over the life-size model so as to obtain a sturdy, life-size, soft, transparent plastic casting. Arterial models made for living subjects with these rapid prototyping techniques can be used to simulate surgical procedures, calibrate imaging modalities, and design new stent grafts.