Portal de Periódicos da CAPES

Fabrication of integral ceramic mold for investment casting of hollow turbine blade based on stereolithography

2009; Emerald Publishing Limited; Volume: 15; Issue: 4 Linguagem: Inglês

10.1108/13552540910979749

1758-7670

Haihua Wu, Dichen Li, Nannan Guo,

Advanced ceramic materials synthesis

Purpose The purpose of this paper is to develop a novel process of integral ceramic molds for investment casting of hollow turbine blades. Design/methodology/approach At first, a resin pattern of a hollow turbine blade prototype is fabricated by stereolithography (SL). And then aqueous gelcasting process is utilized to fill the resin pattern with ceramic slurry of low viscosity and low shrinkage, through in situ polymerization of the slurry a ceramic mold is formed. At last, the ceramic mold for investment casting of hollow turbine blade is obtained by vacuum drying, pyrolyzing and sintering. Findings An integral ceramic mold is successfully fabricated by combining SL and gelcasting process, cores and shell are connected with each other and thus high relative position accuracy is guaranteed. Properties of integral ceramic mold at room temperature and high temperature satisfy the requirements of directional casting for complex‐shaped thin‐walled blades. Research limitations/implications Because the integral ceramic mold is a close body, it is very difficult to directly measure its inner dimensions and the relative position accuracy of cores and shell, and the further research is needed. Originality/value This method enhanced the versatility of using SL prototype in the fabrication of integral ceramic mold for investment castings. Although this paper took a hollow turbine blade as an example, this method is also capable of fabricating integral ceramic molds for other complex investment castings.