Portal de Periódicos da CAPES

The Behavior of Glass Bottles Under Impact

1952; Wiley; Volume: 35; Issue: 9 Linguagem: Inglês

10.1111/j.1151-2916.1952.tb13108.x

1551-2916

R. E. Mould,

High-Velocity Impact and Material Behavior

Journal of the American Ceramic SocietyVolume 35, Issue 9 p. 230-235 The Behavior of Glass Bottles Under Impact R. E. MOULD, R. E. MOULD Preston Laboratories, Butler, PennsylvaniaSearch for more papers by this author R. E. MOULD, R. E. MOULD Preston Laboratories, Butler, PennsylvaniaSearch for more papers by this author First published: September 1952 https://doi.org/10.1111/j.1151-2916.1952.tb13108.xCitations: 7 Presented at the Glass Division Fall Meeting, The American Ceramic Society, Toledo, Ohio, October 6–7, 1950. (Original title, “New Techniques for the Measurement of Transient Stresses in Bottles under Impact.”) Mr. Mould is a G.C.M.I. research physicist at the Preston Laboratories. He is at present on leave from the University of Illinois Physics Department. AboutPDF ToolsRequest permissionExport citationAdd to favoritesTrack citation ShareShare Give accessShare full text accessShare full-text accessPlease review our Terms and Conditions of Use and check box below to share full-text version of article.I have read and accept the Wiley Online Library Terms and Conditions of UseShareable LinkUse the link below to share a full-text version of this article with your friends and colleagues. Learn more.Copy URL Share a linkShare onFacebookTwitterLinked InRedditWechat Abstract The techniques of experimental stress analysis, i.e., bonded wire strain gauges and brittle coatings, were used to study the impact behavior of glass bottles. The magnitude and distribution of impact stresses on both the inside and outside surfaces were determined, and typical impact breakage is discussed in terms of these stresses. Fracture diagnosis on bottles broken by impact correlates well with the observed stress patterns, and these patterns in turn provide a good basis for a detailed study of impact fractures. Duration of impact and dynamic behavior of the bottles were studied with strain gauges and a cathoderay oscilloscope. A typical impact takes the form of a single pulse of about 0.001-second duration and involves peak impact forces of the order of 1000 lb. Citing Literature Volume35, Issue9September 1952Pages 230-235 RelatedInformation