In vitro degradation of Polyactive® 1000PEOT70PBT30 devices
2002; Elsevier BV; Volume: 23; Issue: 1 Linguagem: Inglês
10.1016/s0142-9612(01)00107-7
ISSN1878-5905
AutoresMinna Kellomäki, Senja Paasimaa, Dirk W. Grijpma, Kari Kolppo, P. Törmälä,
Tópico(s)Additive Manufacturing and 3D Printing Technologies
ResumoPolyactive® 1000PEOT70PBT30 (a segmented block copolymer of poly(ethylene oxide terephtalate)/poly(butylene terephtalate) with 70/30 PEOT/PBT ratio) was processed into three different types of samples: injection molded to rods, hot-pressed to films and to composite membranes made by hot-pressing a tubular mesh of poly-l,d-lactide 96/4 between two films of Polyactive®. The molecular weight of Polyactive® was not influenced by processing, but γ-sterilization seemed to increase the weight average molecular weight (Mw). Mechanical properties of the rods and films decreased rapidly in hydrolytic conditions due to the hydrogel nature of the polymer, swelling and degradation. Mesh reinforcement increased the mechanical properties, but the components separated during soaking. In vitro the molecular weight of the rods and films started to decrease immediately, but the PEOT (or PEO) proportion remained relatively constant for 26 weeks. Macroscopically, all the wet devices remained intact, but fragmented on drying. Microscopically, topographical formations of polymer were found on the surfaces and small sodium-rich spots were precipitated onto and inside the polymer. Thermal measurements showed that polymer consisted of amorphous PEOT segments and both amorphous and crystalline PBT segments.
Referência(s)