The operative slip systems and strain hardening behaviour of β′-AgMg single crystals
1972; Wiley; Volume: 14; Issue: 2 Linguagem: Inglês
10.1002/pssa.2210140222
ISSN1521-396X
Autores Tópico(s)Microstructure and mechanical properties
ResumoThe operative slip systems, and the strain hardening behaviour in tension of single crystals of β′-AgMg (CsCl structure) has been investigated in the temperature range from 25 to 298 °K; a few compressive experiments are also reported. It is shown that β′-AgMg crystals deform by slip on the {112} 〈111〉, {110} 〈111〉, {123} 〈111〉, {120} 〈001〉, and {110} 〈001〉 systems. The activation of dislocations of b = 〈111〉 and 〈001〉 depends on the crystal orientation, sense of the applied stress, and temperature. Comparison of the observed slip with those predicted from anisotropic elasticity theory suggests that factors other than dislocation energy and mobility must be considered in predicting the slip systems. The ordering energy and the separation width of a/2 〈111〉 partials and the asymmetry of the Peierls stress on {112} planes appear to play an important role. Crystals which exhibit a linear hardening region (stage II) of relatively low rate of strain hardening slip by the movement of dislocations of b = 〈111〉, while those exhibiting high rate of strain hardening slip by the movement of dislocations of b = 〈001〉 which do not disorder the lattice. Das wirkende Gleitsystem und das Druck–Verfestigungs-Verhalten von β′-AgMg (CsCl Struktur)-Einkristallen unter Spannung wurde im Temperaturbereich zwischen 25 und 298 °K untersucht. Zusätzlich wird über einige Kompressions-Experimente an diesen Einkristallen berichtet. Es zeigt sich, daß β′-AgMg-Kristalle sich durch Verschieben der {112} 〈111〉, {110} 〈111〉, {123} 〈111〉, {120} 〈001〉, und {110} 〈001〉 Systeme deformieren. Die Aktivierung der Versetzung b = 〈111〉 und 〈001〉 hängt von der Kristallorientierung, der Spannungsrichtung und der Temperatur ab. Vergleiche zwischen den experimentell beobachteten und den aus der anisotropen Elastizitätstheorie abgeleiteten Versetzungen lassen vermuten, daß zusätzliche Faktoren zu der Versetzungsenergie und der Beweglichkeit in Betracht gezogen werden müssen, um die Verschiebung zu erklären. Die Anordnungsenergie und die Trennungsbreite von a/2 〈111〉 Teilen und die Asymmetrie des Peierlsdrucks in der {112}-Ebene scheinen eine wichtige Rolle zu spielen. Kristalle mit einem linearem Härtebereich (Stufe II) mit relativ niedrigem Druckhärtungsanteil gleiten beim Versetzen der Verschiebung mit b = 〈111〉, während die mit hohem Druckhärtungsanteil mit b = 〈001〉 gleiten, was nicht zu einer Gitterstörung führt.
Referência(s)