Artigo Revisado por pares

Nanometer-Scale Surface Properties of Mixed Phospholipid Monolayers and Bilayers

1997; American Chemical Society; Volume: 13; Issue: 18 Linguagem: Inglês

10.1021/la970221r

ISSN

1520-5827

Autores

Yves F. Dufrêne, William R. Barger, John‐Bruce D. Green, Gil U. Lee,

Tópico(s)

RNA Interference and Gene Delivery

Resumo

Mixed distearoylphosphatidylethanolamine (DSPE) and dioleoylphosphatidylethanolamine (DOPE) monolayers and bilayers have been deposited on mica using the Langmuir−Blodgett (LB) technique, as a model system for biomembranes. Investigation with atomic force microscopy revealed phase-separation for both monolayers in air and bilayers in water in the form of microscopic DSPE domains embedded in a DOPE matrix. For the monolayers in air, the step height measured between the higher DSPE phase and the lower DOPE phase was larger than expected from the molecular lengths, and a significant contrast in adhesion and friction was observed despite identical lipid end groups. This unexpected behavior resulted primarily from a difference in the film mechanical properties, the DOPE phase being inelastically deformed by the probe. For the bilayers in water, similar trends were found in terms of height, adhesion, and friction, but an additional short-range repulsive hydration/steric force over the DSPE phase contributed to the observed differences.

Referência(s)
Altmetric
PlumX