Portal de Periódicos da CAPES

Artigo Acesso aberto Produção Nacional Revisado por pares

BIBTEX RIS

The Influence of Surface Standardization of Lithium Disilicate Glass Ceramic on Bond Strength to a Dual Resin Cement

2011; Indiana University School of Dentistry; Volume: 36; Issue: 5 Linguagem: Inglês

10.2341/11-009-l

1559-2863

Raíssa R.D. Brum, Rui Fernando Mazur, Juliana Gomes dos Santos Paes de Almeida, Gilberto Antônio Borges, Danilo Biazzetto de Menezes Caldas,

Dental Research and COVID-19

In vitro studies to assess bond strength between resins and ceramics have used surfaces that have been ground flat to ensure standardization; however, in patients, ceramic surfaces are irregular. The effect of a polished and unpolished ceramic on bond strength needs to be investigated. Sixty ceramic specimens (20×5×2 mm) were made and divided into two groups. One group was ground with 220- to 2000-grit wet silicon carbide paper and polished with 3-, 1-, and ¼-μm diamond paste; the other group was neither ground nor polished. Each group was divided into three subgroups: treated polished controls (PC) and untreated unpolished controls (UPC), polished (PE) and unpolished specimens (UPE) etched with hydrofluoric acid, and polished (PS) and unpolished specimens (UPS) sandblasted with alumina. Resin cement cylinders were built over each specimen. Shear bond strength was measured, and the fractured site was analyzed. Analysis of variance (ANOVA) and Tukey post hoc tests were performed. PE (44.47 ± 5.91 MPa) and UPE (39.70 ± 5.46 MPa) had the highest mean bond strength. PS (31.05 ± 8.81 MPa), UPC (29.11 ± 8.11 MPa), and UPS (26.41 ± 7.31 MPa) were statistically similar, and PC (24.96 ± 8.17 MPa) was the lowest. Hydrofluoric acid provides the highest bond strength regardless of whether the surface is polished or not.