Charge Transfer and Photocatalytic Activity in CuO/TiO 2 Nanoparticle Heterojunctions Synthesised through a Rapid, One‐Pot, Microwave Solvothermal Route
2015; Wiley; Volume: 7; Issue: 11 Linguagem: Inglês
10.1002/cctc.201500315
ISSN1867-3899
AutoresSavio J. A. Moniz, Junwang Tang,
Tópico(s)ZnO doping and properties
ResumoAbstract Rapid charge carrier recombination is a major limiting factor over efficiency in many semiconductor photocatalysts. To address this, copper(II) oxide/titanium dioxide (CuO/TiO 2 ) heterojunctions were synthesised through a novel, rapid solvothermal microwave procedure using a low‐cost copper precursor and commercial P25 TiO 2 , taking as little as five minutes to synthesise well‐defined CuO nanoparticles onto the host TiO 2 , achieving an intimate contact. The resultant composites encompass pure CuO particles of approximately 6–7 nm diameter, confirmed by means of high resolution transmission electron microscopy and X‐ray photoelectron spectroscopy analysis. Photoelectrochemical water splitting was enhanced by nearly 2 times using the junction, whilst ≈1.6 times enhancement in the photocatalytic mineralisation of a model organic pollutant 2,4‐dichlorophenoxyacetic acid (2,4‐D) was observed. Furthermore, we studied the initial decomposition mechanism of 2,4‐D by means of GC‐MS analysis. The increase in catalytic activity, investigated by impedance analysis (Mott–Schottky plots) and photoluminescence spectra, is attributed to photoelectron transfer from the more negative conduction band (CB) of TiO 2 to CuO, leaving the photohole on TiO 2 to take part in oxidation reactions. This strategy allows for in situ charge separation which facilitates superior photocatalytic activity for both pollutant degradation and water splitting.
Referência(s)