Portal de Periódicos da CAPES

Shape Optimal Design of Contact Springs of Electronic Connectors

2002; ASM International; Volume: 124; Issue: 3 Linguagem: Inglês

10.1115/1.1463730

1528-9044

Yeh‐Liang Hsu, Yuan-Chan Hsu, Ming-Sho Hsu,

Manufacturing Process and Optimization

An electronic connector provides a separable interface between two subsystems of an electronic system. The contact spring is probably the most critical component in an electronic connector. Mechanically, the contact spring provides the contact normal force, which establishes the contact interface as the connector is mated. However, connector manufacturers have a basic struggle between the need for high normal contact forces and low insertion forces. Designing connectors with large numbers of pins that are used with today’s integrated circuits and printed circuit boards often results in an associated rise in connector insertion force. It is possible to lower the insertion force of a connector by redesigning the geometry of the contact spring, but this also means a decrease in contact normal force. In this paper, structural shape optimization techniques are used to find the optimal shape of the contact springs of an electronic connector. The process of the insertion of a PCB into the contact springs of a connector is modeled by finite element analysis. The maximum insertion force and the contact normal force are calculated. The effects of several design parameters are discussed. The geometry of the contact springs is then parameterized and optimized. The required insertion force is minimized while the normal contact force and the resulting stress are maintained within specified values. In our example, the insertion force of the final contact spring design is reduced to 68.3% of that of the original design, while the contact force and the maximum stress are maintained within specified values.