Portal de Periódicos da CAPES

Microcracks Reduction in Laser Hardened Layers of Ductile Iron

2021; Multidisciplinary Digital Publishing Institute; Volume: 11; Issue: 3 Linguagem: Inglês

10.3390/coatings11030368

2079-6412

Eduardo Hurtado-Delgado, L. Huerta, Argelia Fabiola Miranda Pérez, Álvaro Aguirre-Sánchez,

Surface Treatment and Coatings

A study of surface hardening of Ductile Iron (DI) with and without austempering heat treatment was developed. The chemical composition of the material contains alloying elements such as Cu and Ni, that allow to obtain a Ductile Iron Grade 120-90-02, based on ASTM A536, which was heat treated to be transformed to Austempered Ductile Iron (ADI). Specimens of 10 × 10 × 5 mm3 were obtained for application of surface hardening by Nd:YAG UR laser of 150 W maximum power. The parameters used were advance speed of 0.2 and 0.3 mm/s and power at 105, 120, 135 and 144 W; the departure microstructures were fully pearlitic in the samples without heat treatment, and ausferrite for austempered samples. Microstructural characterization of hardened samples was performed were analyzed and martensite and undissolved carbides were identified in the pearlitic samples, while in ausferrite samples it was found finer martensite without carbides. The depth of hardened surface to different conditions and their respective microhardness were measured. The results indicate that the surface hardening via laser is a suitable method for improving wear resistance by means of hardness increment in critical areas without compromising the core ductility of DI components, but the surface ductility is enhanced when the DI is austempered before the laser hardening, by the reduction of surface microcracks.