Portal de Periódicos da CAPES

An Experimental Apparatus for Icing Tests of Low Altitude Hovering Drones

2022; Multidisciplinary Digital Publishing Institute; Volume: 6; Issue: 3 Linguagem: Inglês

10.3390/drones6030068

2504-446X

Éric Villeneuve, Abdallah Samad, C. Volat, Mathieu Béland, Maxime Lapalme,

Aerospace Engineering and Energy Systems

The icing facilities of the Anti-Icing Materials International Laboratory AMIL have been adapted to reproduce icing conditions on a Bell APT70 drone rotor, typical of small-to-medium UAV models. As part of an extensive icing test campaign, this paper presents the design and preliminary testing of the experimental setup and representative icing conditions calibration in the laboratory’s cold chamber. The drone rotor used has four blades with a diameter of 0.66 m and a maximum tip speed of 208 m/s. For the icing conditions, freezing rain and freezing drizzle were selected. A Liquid Water Content (LWC) calculation methodology for a rotor in hover was developed, and procedures to determine experimental LWC in the facility are presented in this paper. For the test setup, the cold chamber test section was adapted to fit the rotor and to control its ground clearance. Testing was aimed at studying the effect of rotor height h on aerodynamic performance, both with and without icing conditions. Results show no significant effect on the ground effect between h = 2 m and h = 4 m in dry runs, while the icing behavior can be largely influenced for certain conditions by the proximity of the precipitation source, which depend on the height of the rotor in these experiments.