Portal de Periódicos da CAPES

Artigo Produção Nacional Revisado por pares

BIBTEX RIS

Canal Drying Protocols to Use with Calcium Silicate–based Sealer: Effect on Bond Strength and Adhesive Interface

2023; Elsevier BV; Volume: 49; Issue: 9 Linguagem: Inglês

10.1016/j.joen.2023.07.015

1878-3554

Laís Lima Pelozo, Aline Evangelista Souza‐Gabriel, Guilherme Nilson Alves dos Santos, Rafael Verardino de Camargo, Fabiane Carneiro Lopes‐Olhê, Manoel Damião Sousa‐Neto, Jardel Francisco Mazzi‐Chaves,

Surgical Sutures and Adhesives

Introduction The aim of this study was to evaluate the influence on bond strength and interface quality of different canal drying protocols in roots filled with Bio-C Sealer (BCS; Angelus, Londrina, Paraná, Brazil). Methods Ninety-six roots of upper canines were prepared with an R50 file (Reciproc; VDW GmbH, Munich, Germany) and irrigated with 2.5% sodium hypochlorite and 17% EDTA under ultrasonic agitation. Roots were divided according to the drying protocol as follows: dry, the White Mac tip (Ultradent, Indaiatuba, SP, Brazil) for 5 seconds followed by aspiration with a capillary tip for 5 seconds and paper points; slightly moist, the White Mac tip followed by capillary aspiration without paper points; wet, the White Mac tip followed by a single paper point. The roots were filled with BCS or AH Plus (AHP; Dentsply Maillefer, Ballaigues, Switzerland) (n = 16) and sectioned for the push-out test after 3 months. Failure modes were assessed, and the interface morphology was analyzed under scanning electron microscopy. After 6 months, the other half of the roots were evaluated. Data were analyzed by analysis of variance/Tukey test at 5%. The chi-square test was used in the failure analysis and the Kruskal-Wallis/Dwass-Steel-Critchlow-Fligner for interface analysis. Results The AHP-filled roots had the highest bond strength when the canal was dried (P < .05). No difference was found for periods (P > .05). For BCS, the highest bond strength was found in the slightly moist canals (P < .05). A predominance of adhesive failures was observed. The dried canals filled with AHP had the highest percentage of good adaptation, whereas BCS had no difference. Conclusions The best drying protocol for AHP is using the White Mac tip followed by capillary tip aspiration and paper points until complete dryness, and for BCS, it is using the White Mac tip followed by capillary aspiration without paper points.